Access Point Stor-a-key User Manual

Keysafe Code Setting Instructions


Please read the Keysafe code setting instructions below and test the Keysafe combination before placing the lid on the Keysafe. The Keysafe Lid will not work if the combination is set incorrectly. For greater security, please change the combination periodically.

WARNING!

The AP is 802.11 ac wave2/a/b/g/n Outdoor Access Point with speeds up to 400 Mbps on 2.4GHz and 867Mbps on 5GHz band. It can be configuredas an Access Point, or WDS (AP, Station & Bridge). The AP is an affordable solution which is built in high-powered radios and long-range settings to replace the ordinary Access Points that do not. Wireless N150 Access Point WN604. About the Access Point. The Wireless N150 Access Point WN604 is the basic building block of a wireless LAN infrastructure. It provides connectivity between Ethernet wired networks and radio-equipped wireless notebook systems, desktop systems, print servers, and other devices.

Improperly setting the combination is not covered under the Keysafe Warranty.

Write down your code and keep it in a safe place.
The Keysafe cannot be opened without your code. There is no master or default code.


I. Selecting Your Combination

Access Point Stor-a-key User Manual Online


Look at the front of the Keysafe. You will see buttons numbered 1 through 0. You will also see an OPEN button and a CLEAR Button.
There is no preset combination on your Keysafe. You will select your own combination. Select a combination between four and seven numbers in your combination. Each number can only be used one time. Do not use number combinations that can be easily guessed such as your phone number, vehicle license plate or street address. Select a combination and safely record it.


II. Setting Your Combination


Press down on the CLEAR button.
Then press down on the OPEN button and pull out on the lid.


Remove the plastic card from the back of the lid by lifting from the center of the edges.
You will see ten numbered gray buttons with arrows.
These numbers correspond to the numbered buttons on the front of the lid.
There is no preset combination so all the arrows on the screws point to the OFF position. Arrows pointing to the OFF position are not part of combination.


Use the screwdriver tip on the plastic card or a small screwdriver to push and rotate the arrows.
For each number in your combination, apply light pressure and rotate a 180 degree turn so that the arrow points to the ON position and snaps up.
Arrows rotated a 180 degree turn to the ON position are part of your combination.


Access point stor-a-key user manual guide

CAUTION : Check to make sure that all buttons have snapped back up and are all pointing to the ON or OFF position. Arrows must point either to the ON or OFF position or the Keysafe may be damaged.
If any arrow is pointing sideways or has not snapped up, the combination will not work and the Keysafe may be damaged.

Test the combination before putting the lid back on the Keysafe.
Replace the plastic card on the back of the lid.


Attach keys to the key clip.


III. Testing your combination


Point

On the front of the lid, push in the numbered buttons that are in your combination.
You will notice each button will CLICK as it is pressed.
Press down on the OPEN button.
If the combination is set correctly, the OPEN button will slide down fully. If the combination was set incorrectly, the OPEN button will not slide down. If set incorrectly, DO NOT RETURN THE LID TO THE KEYSAFE. Press the CLEAR button and refer to Section II.


Keysafe Instructions PDF's

Keysafe Pushbutton Code Setting Instructions >>
( Keysafe Part Numbers: 1004, 1001, 1000, 1522, 1520, 1194, 1314 )


Keysafe Dial Combination Code Setting Instructions >>
( Keysafe Part Numbers: 1011, 1010, 0124 )


Access Point Stor-a-key User Manual Download

Keysafe P500 Instructions >>
( Keysafe Part Number: 2047, 2048 )

Microsoft access user manual

Access Point Stor-a-key User Manual 2016

Key Cabinet Code Setting Instructions >>
( Key Cabinet Part Numbers: 1795, 1796, 1797 )


Access Database User Manual

Key Cabinet Mounting Instructions >>
( Key Cabinet Part Numbers: 1795, 1796, 1797 )


Access Point Stor-a-key User Manual Free

Push Button Cam Lock Mounting Instructions >>
( Cam Lock Part Numbers: 1773, 1798, 1827 )

Access Point Stor-a-key User Manual Guide